EN
33
8. Mode selector drilling/chiselling
9. Lock for mode selector drilling/chiselling
FIG. 1
10. 1 grease holder
11. Carbon brushes
12. 1 key for grease holder lid
13. Dust cover
14. Accessories (for use with system SDS+)
– 1 pointed chisel (Ø 14 x 250 mm)
– 1 flat chisel (14 x 250 mm)
– 3 masonry drills (Ø 8, 10, 12 x 150 mm)
FIG. 2
USE
PREPARATIONS
WARNING!
Switch off the product, pull out the plug
and wait until all moving parts have
completely stopped before adjusting and/or
maintenance.
Unpacking
• Unpack the product and all the
accessories.
• Check that no parts are missing (see list of
supplied parts).
• Check that none of the parts are
damaged.
• Do not use the product if any parts are
missing or damaged. Contact the retailer.
FITTING THE SUPPORT HANDLE
WARNING!
Always use the support handle and hold the
product firmly with both hands while working.
If you lose control of the product there is a risk
assessment of exposure. The measurement
values have been determined in accordance
with EN 60745-2-6:2010.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
All-round machine with four function modes:
Drilling mode – for drilling in metal, tiles
and wood. Percussion mode – for drilling
in hard materials, e.g. concrete. Chisel with
free rotation – disengaged rotation ensures
maximum freedom of movement. Chisel with
rotation stop – locks the chisel in one position,
for plasterboard and tiles. SDS+ – chuck for
quick and tool-free changing of drills or chisels.
Vibration damping handle for better ergonomics.
Adjustable support handle for more flexibility.
Supplied with the following accessories: Pointed
chisel (14x250 mm) Flat chisel (14x250 mm)
Three drills (8/10/12x150 mm).
1. Lid for grease holder
2. Power switch
3. Mode selector drilling/percussion drilling
4. Vibration damping handle
5. Support handle
6. Bit holder
7. Chuck sleeve
