EN
36
• The product requires very little maintenance apart from regular cleaning.
• Keep the ventilation openings on the product and the area around the chuck clean.
• Clean the product regularly with a dry cloth. Do not use solvent, petrol, or strong or abrasive
chemicals.
STORAGE
• Clean the product before putting it into storage.
• Spray a little MOS2 oil in the bit holder if the product is not going to be used for some time.
This prevents the moving parts on the product seizing.
• Store in a dry, cool and well-ventilated area out of the reach of children.
TRANSPORT
Transport the product in the original pack if possible. Secure the product when in transport.
TROUBLESHOOTING
Problem
Possible cause
Action
The product will not
start.
The power cord is damaged.
Check that the product is correctly
connected to the power supply.
The fuse has tripped.
Check the fuse and reset, or replace if
necessary.
The carbon brushes are worn.
Have the carbon brushes checked, and
if necessary replaced, at an authorised
service centre.
The power switch is faulty.
Have the switch checked, and if
necessary replaced, at an authorised
service centre.
Poor action.
The bit is blunt.
Sharpen, or replace the bit.
The chuck rotates
(or not).
The mode selector for drilling/
chiselling is in the wrong position.
Check that the mode selector is
correctly set for the work to be done.
Percussion drilling is
activated (or not).
The mode selector for drilling/
percussion drilling is in the wrong
position.
Check that the mode selector is
correctly set for the work to be done.
