EN
24
2. Check that the accessory is properly
inserted by pulling it.
3. Remove the accessory by pulling back the
chuck and pulling it out.
Support handle
NOTE:
•
Always check before use that the handle
is correctly and securely fitted.
•
For safety reasons, always use the
hammer drill with the support handle.
1. Fasten the support handle in place by
turning the handle clockwise.
FIG. 3
2. Remove the support handle by turning it
anticlockwise.
Depth stop
1. Press down the lock button on the support
handle and insert the depth stop in
mounting hole in the handle. Adjust the
depth stop to the required position.
2. Release the lock button to lock the depth
stop in place.
STARTING/STOPPING
WARNING!
Wait until all moving parts have completely
stopped before putting the hammer
drill away, adjusting it, or carrying out
maintenance.
1. Hold the hammer drill with both hands and
gently press the power switch to start it.
2. Release the power switch to switch off the
hammer drill.
DESCRIPTION
1. SDS chuck
2. Lock button depth stop
3. Function selector drilling/chiselling
4. Oil cap
5. Power switch
6. Function selector percussion
7. Cap for carbon brushes
8. Support handle
9. Mounting hole depth stop
FIG. 1
Accessories included: Depth stop
USE
INTENDED USE
• The hammer drill is intended for percussion
drilling and chiselling in concrete, masonry,
stone and brick, and for normal drilling in
wood, metal and plastic.
• The hammer drill must only be used
together with approved accessories.
• The hammer drill is intended for private use.
• Do not modify the hammer drill in any way.
ASSEMBLY
Accessories
NOTE:
Accessories fitted to the machine should
be clean and lubricated with a thin layer of
grease.
1. Pull back the chuck and hold it in this
position. Now twist in the accessory until
it automatically snaps in place.
FIG. 2
