EN
40
ADJUSTING THE SAW HEAD
The downward movement of the saw head can
be adjusted to prevent the wheel coming into
contact with the base of the product.
1. Move down the saw head and check if the
wheel comes in contact with the base of
the product.
2. Undo the lock nut (11) on the stop screw
(12).
3. Turn the screw anticlockwise to reduce the
downward movement of the saw head.
4. Turn the screw clockwise to increase the
downward movement of the saw head.
5. Tighten the lock nut when the required
downward movement has been adjusted.
ADJUSTING THE CUTTING ANGLE
The back clamp jaw can be adjusted from 90°
to 45°.
1. Undo the hex screw and the lock screw
with handle.
2. Turn the back clamp jaw to the required
angle.
3. Tighten the hex screw firmly with the
supplied spanner and tighten the lock
screw with handle.
CUTTING WORKPIECES
150–190 MM
The clamp (6) is set at the factory to cut
workpieces with a width of up to 150 mm.
This is the recommended setting. The mitre
fence must be moved on the table (7) to cut
workpieces with a width from 150 to 190 mm.
1. Release the front and back screws for the
mitre fence with the supplied spanner.
2. Move the mitre fence about 35 mm back,
so that the hole and slot in the mitre
fence are in line with the two back holes
in the table.
NOTE:
The spindle screw has a right-hand thread.
Tighten clockwise, unscrew anticlockwise.
5. Remove the spindle screw, the washer and
the outer flange.
6. Move up the bottom guard (5) to the top
guard (4).
7. Remove the cut-off wheel.
Fitting cut-off wheel
WARNING!
Only use sharp and undamaged cut-off
wheels.
1. Check that all components are clean.
2. Fit the cut-off wheel on the inner flange
and spindle. Check that the arrow for the
direction of rotation on the wheel points
in the same direction as the arrow on the
top guard (4).
3. Replace the outer flange, the washer and
the spindle screw.
4. Press the spindle lock button (13) to lock
the spindle.
5. Tighten the spindle screw with the
spanner.
6. Move the spindle guard back to run mode
and tighten the screw.
7. Turn the wheel by hand to check that the
spindle lock has released.
8. Check the fitting by lifting and lowering
the saw head a few times.
IMPORTANT:
After replacing the wheel, run the product
freely for a few minutes to check that it is
working properly.
Summary of Contents for 017523
Page 4: ...1 3 8 6 10 4 7 1 5 ...
Page 5: ...2 2 9 13 12 11 14 ...
