EN
86
Erase all system fault codes
NOTE:
For BMW after model year 2003.
1. Press Erase All System Fault Codes.
The following display image is shown:
FIG. 22
2. Press OK again to erase fault codes or press ESC to cancel. The
following display image is shown when the fault codes are
erased.
FIG. 23
OBDII SYSTEM
Read fault codes
• Stored fault codes are also called permanent fault codes.
These fault codes switch on the fault status light (MIL) when
a fault affects emissions.
• Inactive fault codes, also called mature fault codes or
continuous fault codes, are generated by faults detected by
the control unit during the present or previous cycle, but
which are still not considered to be serious.
• Pending fault codes do not turn on the fault status light and
are not stored in the memory if no fault occurs during the
subsequent driving.
1. Use the up and down buttons to select Read Codes in the
diagnostic menu and press OK.
The message No (pending)
codes are stored in the module is shown if there are no fault
codes! (No pending fault codes stored in the module!) Wait
Summary of Contents for 019327
