EN
40
NOTE:
The copying ring (7) should protrude from the
underside of the base plate.
STARTING/STOPPING
1. Check that the mains voltage corresponds
to the rated voltage on the type plate.
Plug in the plug.
2. Press the power switch lock (24) and then
the power switch (23) to start the product.
3. It is not necessary to keep pressing the
power switch lock (24) when the product
has started.
4. Release the power switch (23) to switch
off the product.
ADJUSTING SPINDLE SPEED
The spindle speed can be set from 11000 to
30000 rpm with the control dial (17). Switch
off the product before adjusting the spindle
speed. Turn the control dial (17) to increase or
reduce the speed (position 1 to 7) as per the
markings on the dial.
ADJUSTING THE DEPTH
1. Check that the plug is not plugged in.
2. Fit the accessories to be used for the work.
This is important because the maximum
cutting depth is limited by the structural
parts of the product. The gap between the
spindle nut (12) and the structural parts of
the product should be about 1–2 mm.
3. Release the locking lever for depth
adjustment (18) by putting it parallel to
the direction of rotation of the spindle.
FIG. 10
4. Put the product on the surface of the
workpiece.
5. Check that the product can be freely
lowered to the base plate (15).
6. Set the depth stop dial (19) to 0 mm.
The lowest level should be below the
depth stop (20).
FIG. 11
7. Undo the locking screw for the depth
stop (22). The depth stop (20) should
be lowered to level 0 mm for the depth
adjustment dial (19).
8. Press down the product until the bit rests
against the workpiece. Lock the product in
this position by putting the locking lever
for depth adjustment (18) at right angles
to rotation axle of the spindle (locked
position).
FIG. 12
9. Bring up the depth stop (20) and turn
the depth adjustment dial (19) to a value
corresponding to the length of the bit,
in steps of 5 mm.
10. Lock the depth stop (20) with the locking
screw (22).
11. Reset the value to 0 mm with the depth
adjustment dial (19).
12. Release the depth stop by setting the
locking lever for depth adjustment (18)
parallel to the rotation axle of the spindle
(unlocked position).
13. Press the product down again and put it
near the edge of the workpiece. Check
that the bit does not protrude below the
edge of the workpiece. If it does, adjust
the cutting depth with the control dial for
the depth stop (21).
14. When checking the cutting depth of the
bit, check that the spindle nut (12) is not
in contact with the structural parts of the
product.
DIRECTION OF FEED
This causes the cutting accessory to cut in the
workpiece, which means that the user has full
control over the product and ensures better
routing and an opposite direction of feed.
FIG. 13
Summary of Contents for 022576
