25
Block up or secure the workpiece in a suitable manner. Keep your hands away from the cutting
area.
Always use the support handle and hold the tool firmly with both hands while working.
Check that the spindle thread protrudes enough for safe mounting of the blade.
Always check before using the blade that is correctly fitted. Never use reducers or adapters.
Start the tool before applying the blade to the workpiece.
Hold the tool firmly with both hands. Always maintain a firm footing and good balance.
The tool must not be used by persons under 16.
Always wear safety glasses and ear protection. If necessary wear other safety equipment, such as
an apron and/or helmet.
Unplug the power cord, switch off the tool, and wait until all moving parts have completely stopped
before working on the tool. Check that the power switch is in the OFF position before plugging in
the power cord.
Keep the power cord away from the work area. The power cord should always be behind you.
The base plate must not be locked when moving the blade down. It must be possible to raise and
lower the blade smoothly.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output
900 W
Speed (no load)
10800 rpm
Spindle thread
M10
Blade
Ø 100 mm
Blade, centre hole
Ø 22 mm
Max. cutting depth
19 mm
Stop angle
0°
–90° / 90°–135°
Weight
3.0 kg
Sound pressure level, L
pA
89 dB(A), K=3 dB
Sound power level, L
WA
100 dB(A), K=3 dB
Vibration level
5.1 m/s², K=1.5 m/s²
Always wear ear protection!
The declared vibration value, which has been measured by a standardised test method, can be used to
compare different tools with each other and for a preliminary assessment of exposure.
WARNING:
The actual vibration level when using power tools may differ from the specified total value,
depending on how the tool is used. It is therefore necessary to determine which safety precautions are
required to protect the user, based on an estimate of exposure in actual operating conditions (taking into
account all stages of the work cycle, e.g. the time when the tool is switched off and when it is idling, in
addition to the start-up time).
