21
Special safety instructions
Never point the air jet at people, animals or your own body. Wear safety glasses to protect your
eyes from foreign objects caught up in the air jet.
Never point tools connected to the compressor at the compressor.
Do not use the machine if you are barefoot, or if your hands and feet are wet.
Do not pull the power cord to remove the plug from the mains, or to move the compressor.
Do not expose the machine to the weather and wind.
Do not transport the compressor with a pressurised air tank.
Do not do any welding or mechanical work on the air tank. Replace the air tank if it gets damaged
or rusty.
Keep children and animals at a safe distance from the work area.
This machine is not intended to be used by persons (including children) with reduced physical,
sensory or mental capabilities. Nor by persons without the requisite experience and knowledge,
unless they receive assistance or instructions by a person responsible for their safety.
Keep children under supervision to make sure they do not play with the machine.
Do not place flammable objects, or objects made of nylon or fabric, near or on the compressor.
Do not clean the machine with flammable liquids or solvents. Only clean with a damp cloth. Check
that the plug has been unplugged from the power outlet.
The compressor must only be used to compress air. The machine must not be used for any other
type of gas.
The compressed air produced by this machine must under no circumstances be used for
pharmaceutical purposes, in hospitals or in the food industry. The compressed air is not suitable for
filling gas tubes for diving.
Do not lift the compressor with the telescopic handle. This handle is only intended to be used to
pull the machine.
NOTE:
This compressor is designed to work with the duty factor specified on the rating plate for technical
data (e.g: S3-25 means 2.5 minutes of operation and 7.5 minutes at rest) to avoid overheating the
electic motor. There is an overheating protection in the motor that automatically switches off the
power supply if the motor overheats. The motor restarts automatically when the normal working
temperature is restored.
To simplify restarting the machine it is important, in addition to the specified steps, to also move the
I/O button to OFF and then back to ON.
All compressors are equipped with a safety valve in the event of irregular functioning of the
pressure switch to guarantee the safety of the machine.
The red line on the pressure gauge indicates the maximum operating pressure of the tank. This
does not apply to the set pressure.
Close the compressed air outlet when fitting a tool.
The use of compressed air for different purposes (pumping, pneumatic tools, painting, washing with
water-based detergents etc.) assumes that one is familiar with and follows the relevant directives
from case to case.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Output
2 hp
Power consumption
5 A
Tank volume
2 x 8 l
Max pressure
10 bar
Intake air
222 l/min
Speed
3400 rpm
Weight
19.8 kg
Dimensions
455 x 415 x 530 mm
Protection rating
IP20
Duty factor
S3-25
Sound pressure level, LpA
77 dB(A)
Sound power level, LwA
95 dB(A)
Guaranteed Sound power level, LwA
97 dB(A)
Always wear ear protection!
Summary of Contents for 200-073
Page 25: ......