EN
51
TECHNICAL DATA
Weight
1.8 kg
Voltage
18 V
Charging time
1-3 h
Speed (no load)
1300 rpm
Blowing speed
I: 110 km/h
II: 210 km/h
Sound pressure level, LpA
75.5 dB(A), K= 2.5 dB
Measured sound power level, LwA
88.26 dB(A), K= 3 dB
Guaranteed sound power level, LwA
96 dB(A), K= 3 dB
Vibration level
1.596 m/s², K= 1.5 m/s²
1.
Tube
2.
Tube lock
3.
Power switch
4.
Handle
5.
Battery
• Make sure the power switch is not
pressed in when inserting or replacing
the battery.
• Connect the battery with moderate
pressure – do not force. An incorrectly
connected battery can damage the
battery terminals, or the battery socket
on the leaf blower.
USE
NOTE:
BATTERY
DESCRIPTION
DIAGRAM
1
DIAGRAM
2
• Use the "Press" button on the battery to
check the charging status; 1-4 red LEDs,
where 1 indicates low battery status.
• The battery must be charged before the
tool can be used.
• After charging for the first time,
use the leaf blower until the battery is
completely discharged. Repeat this
charging and discharging cycle 4 to 5
times.
• If the LEDs on the charger do not go on
when charging:
–
check that the charger’s mains
adapter is properly plugged into the
power point and that the charger is
switched on
–
check that the battery is correctly
inserted in the charger
1.
Place the battery charger on a level
and stable surface. Plug the charger
into a 230 V power point.
2.
Connect the battery to the charger so
that it clicks into place. The red LED
lights up on the charger when correct
contact is made.
3.
When the battery is fully charged, after
about one hour, the red LED goes off
and only the green LED stays on.
4.
Unplug the charger from the power
point and remove the battery from the
charger.
Charging the battery
NOTE:
DIAGRAM
3
DIAGRAM
4
Summary of Contents for Multi Series 000-593
Page 4: ...1 1 2 3 4 5 2 3 4...
