EN
107
Fitting the trimmer spool
NOTE: Remember to put the extension part on the splash guard.
1.
Fit the top clamp on the handle (Diagram 1B).
2.
Turn the blade handle until the hole in the top clamp matches the hole in the top guard
casing. Put the locking pin in the hole to lock the handle.
3.
Screw the trimmer spool in the opposite direction to the direction of rotation (Diagram 2).
4.
Remove the accessory by following these instructions in the reverse order.
Fit the extension on the splash guard
NOTE:
• The extension must always be fitted on the splash guard when using the trimmer spool and
combination splash guard.
• The extension must always be removed when using the grass blade and combination splash guard.
9
2
5
6
1B
1.
Lock nut
2.
Top guard housing
3.
Bottom clamp
4.
Blade
5.
Top clamp
6.
Locking pin
7.
Splash guard A for trimmer spool and
three-toothed brush cutter blade
8.
Splash guard B for forty-toothed blade
9.
Trimmer spool
2
Summary of Contents for 721-349
Page 101: ...EN 101 Open the choke...
Page 127: ......