EN
117
1.
Ignition: Press down the “I” side of the engine switch (Figure 18).
2.
Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not
be completely filled (Figure 19).
3.
Choke: Set the choke knob in the choke position (Figure 20). If you restart a warm engine,
don’t need to operate the choke knob.
WARNING
The choke will automatically return to the run position by operating the throttle trigger.
If you manually turn the choke knob from choke position to run position, the cutting attachment
will start to rotate immediately when the engine is started.
4.
Hold the body of the brush cutter on the ground using your left hand. CAUTION! Do not press
down with your foot. Grip the starter handle, slowly pull out the cord with your right hand
until you feel some resistance (the starter pawls grip). Now quickly and powerfully pull the
cord. Never twist the starter cord around your hand. (Figure 21)
5.
Pull the start cord until the engine starts. Then operate the throttle to allow the choke return
to the run position. NOTE! Do not pull the starter cord all the way out and do not let go of the
starter handle when the cord is fully extended. This can damage the brush cutter.
6.
Then, allow the engine to warm up by applying a slight pressure to the trigger.
NOTE!
Do not put any part of your body in marked area (Figure 22). Contact can result in burns to
the skin, or electrical shock if the spark plug cap has been damaged. Do not use a brush cutter with
damaged spark plug cap. Always use gloves.
19
18
Summary of Contents for 721-349
Page 101: ...EN 101 Open the choke...
Page 127: ......
