6
Shockless Emitters
The Titanium emitter pins on the 971IPS are resistively coupled to the high voltage
supply. This avoids sparking and operator shocks.
Sealed Construction
IP64 or IP65 construction allows the bar to be mounted in areas subject to occasional
wash-down or spillage. If the bar does become wet it must be thoroughly dried before
being powered-up.
Emitter Assembly
The emitter assembly is a one piece moulding with a 1mm diameter sharp titanium
emitter pin. The use of titanium pins has a long history at Meech. Extremely hard
wearing, the pins last for many years. The emitter features castellation that protects the
operator from the point of the emitter. The castellation also allows very easy cleaning of
the pin using a brush. This is a great improvement on other pulsed DC bars. The open
design of the emitter also gives a performance boost over previous systems.
Summary of Contents for Hyperion 971IPS
