User Manual
LTR-1200
31.07.13 TB
22.10.14 SK
Page 5 (18)
5171C
2 Functional Description
2.1 Device-specific Documentation
The following devices can be installed into the LTR-1200. Some of these devices can be connected in
parallel to achieve higher output currents. Please contact Meerstetter Engineering if you have
requirements which currently are not covered by any of these devices.
LDD-Family
(
L
aser
D
iode
D
rivers)
TEC-Family
(
T
hermo
E
lectric
C
ooling Controllers)
LDD-1121
LDD-1124
LDD-1125
TEC-1089
TEC-1090
TEC-1122
TEC-1123
The functional description and the technical data of these devices are documented in their own specific
Datasheets and User Manuals.
2.2 Getting Started
1. Connect the LTR-1200 to the mains power and switch it on.
The display shows the start screen
2. Wait until the LTR-1200 has finished startup.
The display now shows the main screen
No error is indicated (both LEDs are green)
3. Use the navigation switches to browse through the Menu. The Menu structure is documented in
chapter 2.3 Menu Structure
4. Connect to an internal device. (Chose one of the two options below):
(For more information about how to connect please refer to 2.4 Communication Interfaces)
Ethernet (preferred, if possible):
Remote Control over big distances.
Simultaneous connections (multiple applications) to several devices are possible.
Simultaneous connections (multiple PCs) to one device are possible.
o
Set up the IP configuration (See chapter 2.4.2 Connecting LTR-1200 over
Ethernet)
o
Connect the Ethernet cable.
USB:
Easy on-site connection.
Only one device at the same time.
o
Connect the USB Cable.
5. Connect the corresponding (TEC or LDD) Service Software to a device
(Notice that you establish a connection to a device. “Device” and “Terminal” have different
meanings. See chapter 2.4.1 LTR-1200 Communication)
Set up the Service Software connection in the Maintenance Tab (See chapter 2.1
Device-specific Documentation)
When the Software is successfully connected it will show a green status “Connected” and
the Monitor tab will be updated periodically.
If you connect over Ethernet and wish to connect to multiple devices repeat this
procedure for all devices to connect.
6. Now the device(s) are connected. The device configuration and the various setting options are
described in the device-specific User Manuals. (See chapter 2.1 Device-specific Documentation)
Summary of Contents for LTR-1200
Page 2: ......