Prohibited use
Your garden pump is not intended for
permanent operation. The pump may
not be used to pump the following
liquids:
● Drinking water
● Saltwater,
● Beverages or liquid foods,
● Corrosives or chemicals,
● Acids or combustible, explosive or
gasforming liquids,
● Liquids with a temperature above
35 °C,
● Sandy water or water containing
abrasives.
Thermal protection
Your pump is equipped with a thermal
protection switch, which switches the
pump off if it overheats.
The pump will remain off until it has
cooled down. After about 15 - 20
minutes, the pump will automatically
switch on.
hard, flat surface so that it cannot tip
over and so that it will not be near the
flow of water.
the pump is
protected from rain and any direct
exposure to water.
Filling the garden pump
Before putting your garden pump into
operation, you must fill it with water
until it overflows to achieve full suction
power. Do not operate the pump while
it is dry because this will cause serious
damage to the pump.
Switching the pump on and off
socket.
Switching off the system
unplugging the electric cable from the
socket.
Before beginning any maintenance or
cleaning work, make sure that the
garden pump has been unplugged and
take precautions to ensure that it
cannot be switched on during work!
Cleaning the pump
If you have used your garden pump to
pum chlorine water (swimming pool
water) or liquids which leave a residue,
flush your pump out with clear water
after use.
Clearing blockages
If your garden pump should become
blocked so that it does not suction or
pump out liquid, remove the
obstruction as follows:
suction hose from the
pump inlet.
water tap and spray water into the
pump chamber until the blockage is
flushed out.
has been cleared entirely by switching
on the pump for a short time. Do not
let the pump suck air.
-free, put
it into operation as described in the
instructions.
Frost protection
Store your pump so that it is protected
from frost.
Remember to empty it of any
remaining liquid before storing it by
removing the filler screw and dumping
out any water.
Setting up and operating the system
Maintenance and Cleaning
GB 02
