Installation guide solar modules
V1 – April 2015
7 - 19
2.4
Module specification
Please refer to the appropriate MegaCell MBF or MBA datasheet for electrical performance data and
mechanical installation information.
2.5
Product identification
Each module can be identified by means of the following embedded information:
Nameplate:
it is located on the reverse side of the module or on the frame. It gives information about the main
parameters of the module referred to STC condition : Product Type, Maximum Power, Current at Maximum
Power, Voltage at Maximum power, Open Circuit Voltage, Short Circuit Current, all as measured under
Standard Test Conditions, weight, dimensions, Maximum System Voltage, etc.
Warning : bifacial modules increase energy and power production respect to STC nominal data through
Albedo on rear surface. Refer to the specific area on data sheet for real parameters expected after
installation to calculate correctly inverter, cables and connection size.
Serial number:
Each individual module is identified by a unique serial number accompanied with a barcode. They are
permanently inserted inside the laminate, under the front glass of the module, visible when viewed from
the front of the module.
3.
SAFETY INFORMATION
3.1
Important safety precautions
The use of these modules must comply with original design purposes.
o
Installation should be performed only by qualified and authorized personnel
.
Installers should assume the risk of all injury that might occur during installation including, without
limitation, the risk of electric shock.
o
Module installation must be performed in compliance with any applicable local and national
standards, codes and regulations.
o
Within the modules there are no user serviceable parts. Do not attempt to repair any part of the
modules.
o
Modules produce voltage even when not connected to an electrical circuit or load and have no
on/off switch. Modules can be rendered inoperative only by removing them from sunlight, or by
Summary of Contents for MBA-GG60 BiSoN Series
Page 2: ......
Page 4: ...Installation guide solar modules V1 April 2015 4 19...
