AUGUST/30/2004
Shock Sensor Trigger
Trigger on Shock Sensor (Zone 4)
Warn Away trigger
Trigger on Shock Sensor (Zone 1)
Engine Starting
Your vehicle engine starting by
remote control
Engine Running
Your vehicle's engine is running
Driver paging / Lose and Found
Someone is paging you in front of
your vehicle
Temperature Monitor
Indoor temperature of your vehicle
C3
Activate Channel 3 (Trunk
Release).
C4
Activate Channel 4
C5
Activate Channel 5
C6
Activate Channel 6
Time Monitor
Alert Alarm
You have set morning call alarm
Count Down Timer
Reminder when time is up for
parking
Vibration Mode
Remote Control vibrates when the
system is triggered
Low Battery
You have to replace the battery of
remote control.
C. PROGRAMMING OF THE LCD REMOTE TRANSMITTER:
Transmitter Button
Description
Operation
(1 second)
LCD screen lamp turns on for
5 seconds.
Press and hold for 1 second
1 melody sound to confirm enters.
(3 seconds)
Timer Programming Mode.
Press and hold for 3 seconds
2-melody sounds to confirm enter.
-
-
Clear the Flash Icon and Melody Sound
on the LCD Screen Transmitter
Press within 3 seconds
-
(
2-second)
Melody / Vibration
(
)
Mode
Press within 3 seconds
-
(2-second)
Program Count Down Timer
(
)
(10-Minute / 20M / 30 M /1Hour /1.5H /
2.0H)
Press within 3 seconds cycling
*leave the buttons starting count
down then
flashes
1. Screen Lamp ON:
Press and hold the
button one second, with one melody sound and the LCD
screen lamp will turns on for 5 seconds
2. Clear the Flash Icon and Melody Sound:
Press the
button 3 times within 3 seconds will clear the
flash icon and melody sound on the LCD screen transceiver
3. Stop The Trigger Melody Sound:
While triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press any button on the LCD remote transmitter to stop melody
sound
only.
4. Vibration / Melody Mode:
It is useful when you are in a noisy place and difficult to hear beep sound from the remote
control as the remote control in this mode, vibrates itself if your security system is
triggered.
Press the
button first, within 3 seconds press and hold the
button for 2 seconds
to select the mode of vibration or melody, the
icon will displayed on the LCD screen
to show the LCD remote transceiver is on vibration mode.
5. Low Battery Indication:
When the power of the battery weakens, it has two short “bi” sound and flash
icon while pressing the
button of the LCD screen transceiver.
6. Set Up Fixed Count Down Timer:
1. Press the
button first, within 3 seconds press and hold the
button for 2 seconds, the
LCD screen will shows
icon and timer (ie. 0:10) ,
2. Press the
button again showing next order time on the screen ( ie.0:20), press them again
(ie.0:30)…..and so on.
3. Leave the buttons starting count down then
icon flashes
Note:
1.The count down period is fixed as 10 minutes, 20 minutes, 30 minutes, 1 hour, 1.5 hours and 2
hours maximum.
2.When count down timer showing 0:00 means to turn off the timer.
MEGA3700OP
9
