-
Block the vehicle by positioning a wedge tightly on the front and backside of each wheel that is not being lifted off
the ground.
4. OPERATION
-
Move the jack into position.
-
Turn the knob (32) clockwise fully to close the valve
-
Move the pump lever (2) up and down to raise the saddle
-
Adjust the angle screws (75 & 88) to align with the shape of transmission
-
Adjust the angle brackets and the chain to secure the transmission on the saddle
-
Remove the transmission from the vehicle
-
Turn the knob (32) counter clockwise slowly to lower the saddle. Always lower the saddle slowly. Always
transport the load in the lowered position with the chains securely fastened.
-
Reverse this procedure when mounting the transmission.
5. MAINTENANCE
1.
The hydraulic cylinder assembly contains hydraulic fluid that must be kept at approximately 80 % full at all
times for proper operation. To check the level and to fill remove screw (32).
2.
Fill with clean hydraulic fluid only.
3.
Replace the screw
6. LUBRICATION
Lubricate the shaft threads of the angle screw assembly (75 & 88) with Vaseline. Lubricate grease fitting (78)
once every three months, depending on usage, with Vaseline grease.
7
