MegaPoints Controllers
System2 Relay-8 User Reference
Revision 1
megapointscontrollers.co.uk
Page 4
System2 Relay-8 Driver
Introduction
The Relay-8 is an 8 channel relay driver for System2 networks. It
features a Wi-Fi based intuitive configuration from the comfort of
your PC, tablet or phone.
Each relay is individually configurable for:
o
Normal switched operation
o
Pulsed operation
Pulse duration 50ms to 60 sec
You will also need:
Relay modules and cables (see website).
12 Volt DC regulated power supply.
o
500mA per Relay driver.
Network cable (twisted pair).
o
Telephone cable
o
Alarm cable
o
Such as CW1109B/Y supplied by CPC/Farnell .
See website for cable links. Non twisted pair
cable is OK for testing purposes, not for
installation.
To use the network features of this board you will require:
A Wi-Fi Router that is configured for:
o
DHCP (default enabled on most routers)
o
An active internet connection (only required for
software updates).
A current browser that supports HTML5.
This is a 12 Volt device and
should be connected to a
minimum
of
2
Amp
regulated power supply.
MegaPoints Controllers use
static sensitive components
that must be handled with
care.
Avoid
touching
any
components or the circuit
printed on the bottom of
the board.
Avoid placing the board on
any
metallic
surfaces
including track.
DO NOT connect any part
of this device directly to
your track bus.
