MegaPoints Controllers
System2 Relay-8 User Reference
Revision 1
megapointscontrollers.co.uk
Page 23
Below is an example log displayed during the software update process:
Update initiated.
Beginning firmware update. Two downloads will be processed.
Onboard LED will flash erratically indicating data transfer.
The update will take between 4-8 minutes to complete.
An active internet connection is required for success.
Please wait, do not reboot! Update in progress...
Download (1/2). Connecting to update server.
Received 926816 bytes from the update server.
Written only: 0/926816. Please Retry.
Received 926816 bytes from the update server.
Wrote: 926816 bytes successfully.
File (1/2) has been updated.
File (1/2) download complete.
Download (2/2). Connecting to update server.
Received 1507328 bytes from the update server.
Wrote: 1507328 bytes successfully.
File (2/2) has been updated.
Rebooting. Please return to the main web page.
When complete the board will automatically reboot and re-join the network.
All your configuration data remains unchanged and is preserved across updates.
The update will fail safe. This means that if you interrupt the connection or power off during an
update you can return to the update screen and begin the process again though it’s not
recommended to interrupt the update process.
Select the “Click Here” on the bottom line to return to the main configuration page and not perform
any update.
Reboot
Clicking the reboot text will cause the board to immediately restart. You will observe a message in
the Status Log that the page will reload automatically after a few seconds along with a “Please wait
…” in blue.
