1. Introduction
04
05
ENGLISH
ENGLISH
2. Installation
Antenna unit
The elegant plastic housing will protecting the antenna against out-
side weather conditions. Under the housing there is a 460 x 260 mm
high-performance antenna. The new technology of 15-62° elevation
enables optimal reception across Europe.
Control unit
The control unit is used for satellite selection and control. It is connec-
ted between the antenna and the set-top box and supplied the anten-
na with electricity. After successful alignment, the device can be turned
off.
Information:
The Campingman Kompakt 2 Twin has an additional Auto Skew func-
tion that adjust the polarization angle of the LNB automatically, and a
additional connection for a second set-top box. The control unit must
be operated only on the selected antenna port. Only this is provided
for controlling.
Open box and remove the control unit, cables and packing material. Lift the antenna
straight up out of the box. Never place the system upside down!
1.4 System components
2.1 Connection of the Components
Install the control unit and the set-top box is not inside the vehicle in the region of an
airbag. Maintain a careful installation of the cable in order to avoid short circuits. Pay
attention also to existing cables.
Connect the antenna as shown in the illustration below:
Information:
The antenna does not need to
operate with two set-top
boxes mandatory!
Control unit
RED
BLACK
12~24 V DC 5 A
Contr
ol-Bo
x
Ant
enna
Receiv
er
Receiv
er
( - )
(+)
or with the optional
power supply
230 V AC / 12 V DC 5A
Television 2
Television 1
Warning: transport lock
Then remove with the „LOCK“ mar-
ked screw on the bottom of the an-
tenna.
Second port only at
Campingman Kompakt 2 Twin
Campingman Kompakt 2
