31
This section offers a general explanation of how properly to install WSTA-DP250PMS
antenna. Installation of WSTA-DP250PMS antenna must be accomplished by or under the
supervision of an authorized dealer for the Limited Warranty to be valid and in force. The
steps in the installation and setup process are as follows:
Unpacking the unit
Unpacking the unit
Unpacking the unit
Unpacking the unit
1. Open box and remove packing material.
The following items are included in the packaging of Free Way 1S antenna.
Item
Description
Quantity
1
Megasat WSTA-DP250PMS Antenna Unit
1 each
2
Megasat IDU(In Door Unit)
1 each
3
Power Cable(1.5m)
1 each
4
Coaxial Cable (10m)
1 each
5
Coaxial Cable (1m)
1 each
6
User Manual
1 set
7
Gluing set (Primer 50ml, Applicator,
Special adhesive 310ml)
1 set
Table 2-1 Parts included
2. Lift dome out of box vertically. Then lift unit out of box vertically. Do not turn box
and “roll” out, or turn upside down to remove.
Figure 2-1 Unpacking the unit
Lift Unit straight
up out of the
carton!
I
nstallation
nstallation
nstallation
nstallation
