10
4. Lubrication
潤滑
Too much oil or not enough oil can cause oil
太多或太少的油會造成機器漏油和機器故障。
leakage and/or damage to machine . Be sure to
維持油的水平在2條線之間。
keep the oil level between two red lines.
4.3 Refilling oil
4.3 補充油
Replenish with an oiler a drop of oil at the points
indicated with arrows.
If excessive oil left around the presser foot and the
upper knife, material can be stained unexpectedly.
Be sure to wipe it out completely. (Fig. 17, 18 & 19)
用油壺在箭頭處滴一滴油來潤滑。但如果使用過
多,而讓油滴濺在壓腳和上刀周圍,會導致布受
油染汙。要確實把多餘的油擦乾淨。(圖
17,18 & 19)
Fig. 17
Fig. 18
Fig. 19
If too much oil lubrication is applied, material can
太多的潤滑油會使布料沾汙。
be stained.
CAUTION
注意
CAUTION
注意
Summary of Contents for MJ101TX
Page 1: ......
Page 4: ...1 1 Name of each part Fig 1...
Page 5: ...2 2 Installation 2 1 Installation 2 1 2 1 1 Tabletop type 2 1 1 Fig 2...
Page 45: ......