14
使用說明
5. Proper operation
5.3 Threading
5.3 穿線
Refer to Fig. 23 to conduct threading correctly.
正確穿線,參考圖23
E :
上打網線
當穿線至此時,把線結剪掉,再穿入針孔。
TIP
When raising presser foot,
thread tension will be evenly released,
and threading through take up can be
smoother.
小提醒
當抬起壓腳時,
線架組會平穩的放開,如此穿線
至凸輪會順暢些。。
Inproper threading can cause thread breaking, stitch
skipping, and uneven stitching. No need to remove
needle plate when conducting lower lopper threading.
Fig. 23
提醒:不當的穿線會導致斷線、跳針、線跡
不整。穿下鉤針線時不須把針板拆掉。
Then cut off the thread knot and rethread through needle eye.
E : Top cover thread When threading up here, cut off the thread knot and conduct the threading.
F : Lower looper thread
A, B, C, D Needle threads … When threading, pull the thread out until they reach the needle clamp.
F :
下勾針線
A, B ,C ,D
針線
先用易穿的線從
ABCDEF
孔穿至針鎦前,然後結上要用的線拉到針前把結剪掉。
NOTE
Summary of Contents for MJ101TX
Page 1: ......
Page 4: ...1 1 Name of each part Fig 1...
Page 5: ...2 2 Installation 2 1 Installation 2 1 2 1 1 Tabletop type 2 1 1 Fig 2...
Page 45: ......