20
5. Proper operation
使用說明
5.10 SP device
5.10 過線油組
SP device, for needle thread oiling, is equipped
to prevent thread from breaking and stitch from skipping
when a machine is running at a high speed or using
synthetic thread and/or synthetic fabric.
Fix the felts
①
, including accessories, into the SP tank
②
.
(Fig. 34)
當機器在高速運轉或使用特殊線或特殊纖維時,
矽油壺組是標準配備,以防止斷線跳針。
當使用機器時,將毛氈
①
放入矽油壺
②
內。
Fig. 34
(圖34)
1. When SP device is not used, remove the felts
①
.
1.當不使用矽油壺組時,要取出毛氈
①
。
If not removed, irregular condition may occur
不然可能在車縫時發生不正常情況。
during sewing.
2.當矽油沾到其他零件時,可能引起機器
2. If the silicone oil is sticked to the parts other
損傷。故要將油擦乾淨。
than SP device, the parts may be damaged.
Be sure to wipe silicone oil away.
Use dimethyl silicone oil.
Open the oil cup lid
③
and check the oil amount.
If not enough, supply oil into the SP tank
②
. (Fig. 34)
使用乙烷樹脂
打開油壺蓋
③
,檢查油量。如果不夠,添加油於
油壺
②
。(圖34)
CAUTION
注意
Summary of Contents for MJ101TX
Page 1: ......
Page 4: ...1 1 Name of each part Fig 1...
Page 5: ...2 2 Installation 2 1 Installation 2 1 2 1 1 Tabletop type 2 1 1 Fig 2...
Page 45: ......