36
調節裝置
6. Adjustments
Resetting :
重排:
Refer to Figs. 65-71 for resetting.
將圖65-71重新安裝
(1) Remove all needles. Reset the presser foot, c. set
(1) 拆掉全部的針重新裝上壓腳在左右壓腳檔之
between the presser foot guides(left) and (right)
間,向右旋轉,放正壓腳。
while turning it to the right diagonally from the
(2) 重新裝上上勾針驅動片
⑪
到帶動桿
⑫
back.
裡面。
(2) Reset the carrier/hook driving segment
⑪
on the
(3) 安裝壓腳柱插入上勾針驅動片
⑪
後鎖上壓
lever
⑫
on the carrier/hook driving sleeve.
腳後面的螺絲
⑧
。
(3) Insert the presser bar into the carrier/hook driving
(4) 檢查壓腳是否順暢沒有左右晃動,如果有卡
segment
⑪
and tighten the screw
⑧
on the back
住,鬆開左壓腳檔
⑬
的螺絲
⑭
去調整。
of the presser foot.
(5) 重新裝上刀台
⑤
固定在刀座
⑥
支撐架上。
(4) Check the presser foot moves smoothly without
(6) 調整刀台和上刀的位置,當針在最低點的時
play right and left. If not, loosen the screw
⑭
of
候。(參考"6.12 置換和調整位置")
the presser foot guide(left)
⑬
to adjust it.
(7) 當壓腳緊貼在針板上和針在最低點時重新裝
(5) Reset the knife holder guide collar, c. set
⑤
and
上調整螺帽
②
然後輕微的壓下螺絲
③
並
the upper knife on the knife holder bracket
⑥
鎖上。
with two screws.
(8) 裝回油塞
①
。
(6) Adjust the positions of the knife holder guide collar
(9) 裝回所有的針。
and the upper knife when the needle is at the lowest
point. (See "6.12 Replacing and adjusting knives" )
(7) Reset the adjusting screw
②
when the needle is at the
lowest point and the presser foot touches closely on the
stitch plate. Then tighten the screw
③
of the presser bar
connecting bracket while pushing slightly down.
(8) Reset the seal plug
①
.
(9) Reset all needles.
Before adjusting, ALWAYS turn the motor switch
在調整機器之前,一定要先把電源關掉還有確定馬
OFF and check that the motor has already stopped.
達完全停止。
WARNING
注意
Summary of Contents for MJ101TX
Page 1: ......
Page 4: ...1 1 Name of each part Fig 1...
Page 5: ...2 2 Installation 2 1 Installation 2 1 2 1 1 Tabletop type 2 1 1 Fig 2...
Page 45: ......