14
7.2.
Install Navigation LCD Panel (PND)
LCD uses resistive screen, it supports road navigation, making a phone call, send and receive
SMS, and send target location remotely, etc. (Please connected the external power when you
use it).
1
Red +5V
DC IN is 5V when tracker connect to the external power source
2
Dangling
3
Green RS232 RX
Port of LCD receiving data
4
Dangling
5
Yellow RS232 TX
Port of LCD sending data
6
Dangling
7
Blue GPS RX
Port of receiving GPS data
8
White GND
Ground
7.3.
Install temperature sensor
It uses DS18B20, the measuring range of temperature is +125 ~
℃
-55 ; up to support two
℃
ways temperature sensor. Waterproof and the longest wire length can be customized to 5m.
1 Black GND Ground
2 Yellow T2
Temperature detection has two ways output, this is second way
3 Red VCC Power output’s port (also can work normally without external power source)
4 Yellow T1
Temperature detection has two ways output, this is first way
