Megatherm wood-pellet burner
MPB 90 Pro
3.
FAN POWER (IGNITION)
In this parameter the producer sets the power of the fan during the pellet's ignition. The
fan's power is set in the bracket of 5 to 50%.
If chimney's draught is over -15Pa, then the parameter stays at 10%
If chimney's draught is from 0 to -15Pa, then the parameter must change to 15-20%.
Manufacturer Advise:
10%
4.
PELLETS DOSE (IGNITION)
In this parameter the manufacturer sets the dose of fuel needed to ignite the burner. The
parameter is set in the bracket of 50 to 500 grams. Depending the pellet's quality the
parameter can change.. The default value is 180grams
Manufacturer Advise:
180-200gr
. Depends on pellet quality
5.
FEEDER PERFORMANCE
In this parameter the manufacturer sets the performance of the feeder. The whole work of
the burner is based on this parameter. The parameter is set in the bracket of 5 to 99 kg/h
with the step of 500grams.
Manufacturer Advise:
Can not be given any advise since it is depended on the
feeder's angle and pellet quality. Please follow the procedure on paragraph 11
“First use”
6.
PELLETS FEEDING PERIOD
In this parameter the manufacturer sets the period of feeding the pellet. After the lapse of
time, the driver releases the next dose of fuel. In the cycle of maintain, the parameter is
ten times multiplied. The feeding period of the pellet is set in the bracket of 10 to 60
seconds.
Manufacturer Advise:
10-20s
7.
OVERFLOW AIR (WORK)
In this parameter the manufacturer sets the overflow of the air needed to burn the
specified amount of the pellet during
maximum work power of the burner.
This
parameter should be increased if during the working cycle too low capacity of the fan would
be noticed. The overflow of the air is set in the bracket from 0.10 to 4.00
Manufacturer Advise:
Can not be given any advise since it is depended on power,
pellet, chimney draught, etc..
8.
OVERFLOW AIR (MAINTAIN)
In this parameter the manufacturer sets the overflow of the air needed to burn the
15
