Megatherm wood-pellet burner
MPB 90 Pro
7.
Operation functions
After switching the driver on, on the LCD screen appears the program's logo defining the
type of the driver, current version of software and the manufacturer's logo.
While activating, the driver carries out a test of the connected sensors. In case of one
lacking, on the screen appears an appropriate message (---). The work of the driver
without a heating water temperature sensor (CH) is blocked and an emergency mode is
activated (CH pump is still on).
Correct connection of sensors causes displaying of actual CH furnace's temperature and the
temperature of useful warm water of the WUW buffer (if the function is active). On the
screen appears which function is currently used by the driver.
The driver may work in three working modes (“STOP”, “IGNITION”, “AUTOMATIC WORK”).
The change of the working mode happens when the “MODE/ ” button is pressed on the
regulator's panel. Activating the “STOP” mode is possible in all modes after pressing the
“MODE/ ” button for 3 seconds. This mode activates procedures connected with the
burner's putting out i.e. burning off and cleaning.
While activating the driver for the first time, the
“STOP”
mode is activated. Every next
time, its status is saved in the regulator's non-volatile memory. Activating the driver again,
9
PELLETS DRIVER
** REG-03/G v4.0 **
CH:---- C WUW:---- C
STOP
CH:39.5 C WUW:23.6 C
IGNITION...
CH temperature WUW temperature
Burner function
