M
AVTMMIT30-EN Rev E02 June 2009
24
INSPECTION AND
MAINTENANCE PROCEDURE
Proceed according to the steps below:
1.
Visually inspect the unit case, noting that
hinges and case locks function properly
2.
Check for breaks and or cracks in the case or
lid
3.
Check that the cable bag remains firmly
affixed to the lid
4.
Remove the cables from the bag and set them
aside.
5.
Take note of the air transport valve; that it
rotates smoothly and cinches down firmly.
6.
Note the condition of the carry handle and
case feet.
7.
Wipe the exterior of the case with a damp
cloth; then dry with a clean dry cloth.
Detergents and special cleaning agents are
neither required nor necessary.
8.
Retrieve the cable set aside earlier, inspect the
cables looking for damaged insulation or
frayed jackets. Pay special attention to the HV
output cable, check the condition of the
crocodile clip, and ensure that the spring
tension is sufficient and not damaged. The
Summary of Contents for MIT30
