Megger MIT510, User Manual

12

REPAIR AND WARRANTY

The instrument contains static sensitive devices, and care must be taken in

handling the printed circuit board. If an instrument’s protection has been

impaired it should not be used, but sent for repair by suitably trained and

qualified personnel. The protection is likely to be impaired if for example; it

shows visible damage; fails to perform the intended measurements; has

been subjected to prolonged storage under unfavourable conditions, or has

been subjected to severe transport stresses.

NEW INSTRUMENTS ARE GUARANTEED FOR 3 YEARS FROM THE

DATE OF PURCHASE BY THE USER.

Note:

Any unauthorized prior repair or adjustment will automatically

invalidate the Warranty.

INSTRUMENT REPAIR AND SPARE PARTS

For service requirements for Megger Instruments 

contact

:

Megger Limited

or

Megger    

Archcliffe Road   

Valley Forge Corporate Centre

Dover 

2621 Van Buren Avenue

Kent  CT17 9EN

Norristown PA 19403

England.

U.S.A.

Tel:  +44 (0) 1304 502 243

Tel:  +1 610 676 8579

Fax: +44 (0) 1304 207 342 

Fax: +1 610 676 8625      

or an approved repair company.

Returning and Instrument for Repair

If it is necessary to retun an instrument for repair, a returns Authorisation

number must first be obtained by contacting one of the addresses shown.

You will be asked to provide key information, such as the instrument serial

number and fault reported when the number is issued. This will enable the

Service Department to prepare in advance for the receipt of your

instrument, and to provide the best possible service to you.

The Returns Authorisation number should be clearly marked on the outside

of the product packaging, and on any related correspondence. The

instrument should be sent, freight paid to the appropriate address. If

appropriate a copies of the original purchase invoice and of the packing

note, should be sent simultaneously by airmail to expedite clearance

through customs.

For instruments requiring repair outside the warranty period a repair

estimate will be submitted to the sender, if required, before work on the

instrument commences.

Approved Repair Companies

A number of independent instrument repair companies have been

authorised for repair work on most Megger instruments, using genuine

Megger spare parts. A list of approved companies is available from the UK

address shown on this page. Spare parts are also available.