2
SAFETY WARNINGS
•
The Test Set must be properly earthed before use.
•
The output terminals must be clean and free of grease and dirt before switching on.
•
The output test leads must be of the correct rating.
•
The Test Set must be switched Off by the power switch before any connections on the set
or the equipment under test is touched.
•
After a period of testing under full load, the terminals and lead connectors may be hot.
•
The equipment under test must not be touched while the power is switched On.
•
The permitted duty cycle must not be exceeded.
•
Replacement fuses must be of the correct type and rating.
•
The main current terminals must not be connected to a live potential.
•
The Test Set must be switched Off when resetting circuit breakers.
•
Refer also to page 10 for further explanations and other precautions.
•
Warnings and Precautions must be read and understood before the Test Set is used.
They must be observed during use.
NOTE
THE TEST SET MUST ONLY BE USED BY TRAINED AND COMPETENT PERSONS
Symbols used on the Test Set :
Caution: Refer to accompanying notes.
Caution: Risk of electric shock.
Caution: Hot surface
Equipment complies with relevant EU
Directives
Summary of Contents for PCITS2000/2
