Configuration
54
6.3.4
Specifying the outgoing mail server
To send email notifications, the data of an SMTP server (used by mail providers to send
mail messages) must be entered. An existing or specially set-up account with a public
email provider can also be easily used for the sending of emails. The address and port
of the SMTP server can usually be found very easily in the Internet.
The data of the SMTP server can be entered under the menu item
Settings
Communication
Email service
:
Parameter Description
IP address of
mail server
IP address of the SMTP server
If only the URL of the server is known, the IP address can be
determined with the command
nslookup
(followed by the URL of the
server) in the Windows console (e.g.
nslookup smtp.gmail.com
).
Port
Port of the SMTP server
Login
Login of the email account used
Password
Password of the email account used
The settings must then be saved using the
button.
6.4
Configuring trigger events for connected measurement
equipment
If a suitable measuring device (for example, a reflectometer) has been connected to the
trigger output
of the supply module, then you can use the
Settings
Fault
location
Trigger
menu to define at which points in time the measuring device will be
triggered by the supply module with a voltage pulse between 15 and 20 V:
Parameters
Description
PM-A | PM-B | PM-C
Selection of the power modules whose switching operations
entail triggering of the connected device.
Triggering always occurs when the power switch in one of the
activated power modules is switched on.
Triggering always occurs when the power switch in one of the
activated power modules is switched off due to a fault current.
