17
MACHINE GETS TOO HOT:
Check speed control and allow 20
minute intervals between each procedure.
TROUBLESHOOT
INCONSISTENT OR NO POWER:
Verify that machine is turned on.
Make sure all cords are attached properly.
Try with different speed control or adapter.
Make sure the right Lumi Pen A/B is selected.
NEEDLE DOES NOT MOVE OR NEEDLE HESITATES
Check all components are assembled correctly.
Replace dull needle with a new one.
MAINTENANCE
Remove the power adaptor by holding the plug.
Please do not pull the cords.
Handle the device with care.
Do not use abrasive material to clean the device.
If your device does not operate after the above steps have been
taken, please contact your distributor for warranty options.
Lumi Digital Device is designed for micropigmentation purpose and
for trained professional use only. Neither MEI-CHA or its affiliates
assume responsibility or liability for any injuries or damages,
resulting, directly or indirectly, from the use of this product.
Summary of Contents for Lumi
