Inputs and Outputs
The EX-G053B has four inputs and accepts both graphics and video signals, which come from
computers and NTSC/PAL video sources respectively. There is a concept of main channel and sub
channel for this device. You can pick up two of the four inputs, one is for main channel and the other is
for sub channel, and then display two of them simultaneously on the same screen. Figure 2 shows the
rear panel connectors of a EX-G053B and Table 1 illustrates how you can connect video devices and
display to the EX-G053B.
Figure 2: Rear Panel
1.
Power
connector
4.
Composite
input
2. DVI / VGA output
5. DVI / VGA / Component input
3. VGA input
6. DIP switch
*
(for firmware & system reset)
*
Default: Turn on the EX-G053B then switch both two DIP switchers simultaneously
up and down to factory default mode.
*
These IO ports support various resolution from 640x480 up to 1920x1200, for more
detail of the supported modes, please refer to the Appendix – Supported
Resolution.
2
5
1
6
3
4
+5V DC
Table 1: I/O Connectors
Input Connector
Video Source
[1] DVI
[2] VGA — with a DVI-to-VGA adapter
(DVA01)
[3] Component (YPbPr) — with a DVI-to-VGA adapter
(DVA01)
and a
VGA-to-component breakout cable
(VYPBA01)
[4] 1x DVI + 1x VGA — with a DVI-to-DVI/VGA breakout cable
(DDVY01)
DVI-IN
[5] 1x DVI + 1x Component (YPbPr) — with a DVI-to-DVI&VGA breakout cable
(DDVY01)
and a VGA-to-component breakout cable
(VYPBA01)
VGA
[1] With a VGA cable
Composite
[1] With a RCA cable
Output Connector
Display
[1] DVI display
[2] VGA display — with a DVI-to-VGA adapter
(DVA01)
DVI-I OUT
[3] 1x DVI d 1x VGA display — with a DVI to DVI&VGA breakout cable
(DDVY01)
Page
8
of
24
