MeiG
Product
Manual
of
SLM750
Module
SLM750
Module
Hardware
Design
Page 84, total 84 pages
band emissions) with the Radio essential requirements. The host manufacturer must verify that there
are no additional unintentional emissions other than what is permitted in the Part 15 Subpart B or
emissions are complaint with the Radio aspects.
FCC RF Exposure Requirements
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter and must be installed to provide a separation distance of at least 20cm
from all persons.
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
EU DECLARATION OF CONFORMITY
Hereby, MeiG Smart Technology Co., Ltd declares that the radio
equipment type SLM750 is in compliance with Directive 2014/53/EU.
The most recent and valid version of the DoC (Declaration of Conformity) can be
viewed at www.meigsmart.com/en/product-certification.
