6
Working with KOOI-REACHFORKS®
The KOOI-REACHFORKS®, type RE, are connected via a flow divider that enables both forks to slide in and out simulta-
neously. The accuracy of the flow divider allows a maximum length discrepancy of 4% while sliding the KOOI-REACH-
FORKS® in and out.
To minimise wear, avoid allowing the KOOI-REACHFORKS® to come in contact with the ground during operation . In
order to reduce wear:
•
The manufacturer can weld a wear-resistant plate under the sleeve which can be replaced when worn out.
•
The chains in the forklift mast can be shortened so that the KOOI-REACHFORKS® cannot reach the ground.
Maintenance Schedule
Nº
Description
Weekly
Monthly
6 months or
every 1000
hours
Annually or
every 2000
hours
1.
Grease the underside and topside of the
inner fork
2.
Check inner fork for leaks
3.
Check wear strips for any sign of wear*
4.
Check sleeve for signs of wear, espe-
cially the heel side (REE/REEN type also
wear plate)
5.
Check for and remove any dirt in the
sleeve
6.
Check for any cylinder head leaks
7.
Check inner forks in accordance with
ISO 5057* standards
*See chapter on ‘Wear’.
Notes on ‘Maintenance Schedule’
•
Recommended lubricating grease: Nova-
tex EP2 (point 1).
•
In the event of leakage, immediately
remove the forks from the forklift and
contact your supplier (point 2).
•
If defects are detected, solve the problem
/ replace parts before proceeding to work
with the KOOI-REACHFORKS®.
•
See chapter on ‘Instructions for Re-
placement of Sleeve’ and ‘Instructions
for Replacement of Hydraulic Parts’ for
further explanation about replacing parts
and required tools.
