WasteStar installation operating instructions FC
9670512
Design and construction subject to change without prior notice!
Page
24
of
40
9
Operation the WasteStar FC
System operators must be very familiar with the Operating Instructions. Incorrect
operation may result in personal injury or material damage.
9.1
Operation WTS-A
•
The feeding station is switched on by briefly pressing the white ON button. This
is confirmed when the ON button lights up.
•
Put the collected organic kitchen and food waste into the funnel.
•
Suction of the feeding station is started by briefly pressing the white ON button.
•
The feeding station is switched off by pressing the black OFF button.
Note 1!
The orange "release" light on the control panel means the system is ready for suc-
tion.
Note 2!
Whenever the feeding is switched on, the white ON button flashes if there are any
errors detected. A fault can be reset at this station by pressing the OFF button and
then the ON button again.
If the ON button continues to flash after the feeding station has been switched back
on again, contact building services immediately. Suction can be continued only af-
ter the fault has been rectified and the error message has been acknowledged on
the touch panel (switch cabinet in the wet waste area).
Note "high vacuuming power"!
If the funnel is not emptied after the suction process, you can start a suction pro-
cess with high vacuuming power by pressing the white ON button and holding it for
more than 2 seconds.
Summary of Contents for WasteStar FC
Page 40: ......
