WasteStar installation operating instructions FC
9670512
Design and construction subject to change without prior notice!
Page
34
of
40
15.1 Basic safety measures during normal operation
DANGER
Risk of injury due to electric shock! Damage to property!
Switch off the power supply using the locally available mains disconnector prior to
any maintenance or repair work and secure it with a padlock!
The key for this lock must be kept in the hands of the person carrying out the
maintenance and repair work!
Failure to observe these precautions can result in severe injury or damage to proper-
ty.
WARNING
Risk of injury or severe injury!
Caused by unauthorised access.
Set up a safety fence during maintenance procedures to prevent unauthorised ac-
cess.
Existing safety systems must not be removed!
As a matter of principle, no safety systems may be disassembled or decommissioned
(except in the event of maintenance and repair work)!
Danger of scalding/burning!
Before carrying out any maintenance and repair work, ensure that all the parts of the
machine that may be touched have cooled down to room temperature!
15.1.1 Before setting in operation - after maintenance and repair
works
Legal requirements relating to the avoidance of waste materials and to their recy-
cling/removal in accordance with applicable regulations must be observed!
In particular, during installation, repair and maintenance work, materials that could
pollute water must not pollute the ground or run into the sewerage system:
•
Grease and oils
•
Hydraulic oils
•
Coolant
•
Cleaning fluids containing solvents
These materials must be stored, shipped, collected and disposed of in suitable
containers!
16
Maintenance manual
NOTE
Maintenance work should
only
be conducted by authorised MEIKO personnel.
Whenever any electrical components are disconnected and reconnected, re-
placed or repaired, a safety test must be conducted, at least on these compo-
nents!!!
Summary of Contents for WasteStar FC
Page 40: ......
