11 Technical Appendix
11.8.20.3 Configuring an BPE expansion card via the Web Interface
A simple BPE expansion card usually gets its signals directly from the internal backplane of the system. The
output signals of the card are pre-configured according to customer requirements.
If an output signal has to be changed, this must be done via the pre-connected receiver - in the menu "Clock
→
Switch Card" if you have a redundant system or in the menu "Clock
→
Receiver" in systems with only a single
receiver. The BPE modules have no direct configuration options. This information is also displayed in the "IO
Config" menu.
Figure: menu "Clock
→
Switch Card
→
IRIG Settings"
Figure: menu "Clock
→
Programmable Pulses
→
Selection of Idle mode"
IMS - LANTIME M4000
Date: 27th May 2021
115
