12.7 Replacement or Installation of a Hot-pluggable IMS Module
Please use a Torx screwdriver (T8 x 60) for removal and installation.
1.
Follow the safety instructions at the beginning
of this manual!
1.
Remove the two marked Torx screws from the
module holder plate or the cover plate of
the empty slot.
2.
(Only for an already built-in module)
Pull the module carefully out of the holding
rail. Note that the module is firmly anchored
in the connector block of the housing. You need
a certain amount of force to release the module
from this link. Once the connection to the
connector block of the system’s backplane is
loosened, the module can be easily pulled out.
3.
When installing the new IMS module, please ensure that the board is correctly inserted into the
two guide rails of the system housing. Non-observance can cause damage to the module and the chassis.
Make sure that the module is securely locked into the connector block before you fasten the two screws.
4.
Now you can put the installed module into operation.
Attachment points of an 1U IMS system
26
Date: 21st August 2019
IMS-M4000
