29
immediately, the display will show the remaining time.
NOTE:
The red dot next to power level indicator will
illuminate for those zones be set with timer. You can check
timer setting of different cooking zone which set with timer,
by active this cooking zone.
NOTE:
If more than one heating zone has timer setting,
the timer indicator will show the lowest time. The red dot
next to power level indicator will flash.
5. When cooking timer expires, the corresponding
cooking zone will be switch off automatically.
Note:
The default setting of minute reminder and timer is 30 minutes.
Note:
After adjusting, the setting in timer indicator will flashing for 5 seconds and
then stop flashing, then the setting be confirmed.
Note:
The minute reminder and timer can be use at same time, timer indicator
shows the lowest time setting. If the lowest setting is minute reminder, the red
dot next to timer indicator will flash. If the lowest setting is timer setting, the red
dot of corresponding cooking zone power level indicator will flash.
Note:
If indicator shows timer setting of cooking zone. To check minute reminder
setting, press the timer control button , the indicator will show minute
reminder setting.
Detection of Pan and Small Articles
For induction hob, if display flashes ” “alternately with heat setting.
• you have not placed a pan on the correct cooking zone or,
• the pan you’re using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
Notes:
1. No heating takes place unless there is a suitable pan on the cooking zone.
2. The display will auto turn off after 2 minutes if no suitable pan is placed on it.
3. When an unsuitable size or non-magnetic pan (e.g. aluminum), or some other
small item (e.g. knife, fork, key) has been left on the hob, the corresponding
cooking zone will automatically turn off in 1 minute.
Residual Heat Warning
Beware of hot surfaces