DMW-22-TDL SERVICE MANUAL
Confidential and proprietary information of Meister Cook, LLC. Not to be reproduced or used in any manner other than
with the express written permission of Meister Cook, LLC.
7
|
P a g e
electrocution hazard
. If there is damage to the cord or plug,
the power cord must be
replaced in its entirety with a factory authorized cord
.
Turn on the power switch for the DMW
.
If it is desired to toggle to the English menu presets, press and hold
Bin 1
while the
firmware version is displayed. The change will be confirmed by four (4) beeps.
If it is desired to toggle to the French menu presets, press and hold
Bin 2
while the
firmware version is displayed. The change will be confirmed by four (4) beeps.
Verify that the desired presets are selected. Verify that the presets for each chamber share
an identical setpoint temperature. Remember, the highest temperature setpoint controls the
chamber temperature.
Allow the DMW 25-35 minutes to preheat.
Basic Operation
NOTE:
after 10 seconds of inactivity, the UI will time-out and return to the home display.
To display the current temperature for each chamber:
Press and hold
Temp.
NOTE:
the temperatures are also automatically displayed on a scrolling basis on the
UI. This allows the operator to be able to see the temperatures even when they are
standing afar from the DMW.
To toggle between AM and PM menus:
Press and hold
AM/PM
until the green LED shifts position. The top LED indicates AM,
and the bottom LED indicates PM.
To toggle between presets:
Press and hold
Prog
.
Press
Bin #
.
Press
+
or
–
to scroll through the available presets.
To save, press and hold
Prog
. The save is confirmed by 2 beeps.
To cancel, either press
AM/PM
or simply wait 10 seconds for a time-out.
To set or cancel a timer:
Press and hold
Bin #
.
NOTE:
the display will be brightly illuminated only if it is the first timer set for that
particular preset. This provides first-in/first-out functionality.
To silence a timer alert:
Press
Bin #
.
