4 Power tool use and care
a
Do not force the power tool. Use
the correct power tool for your
application.
The correct power tool
will do the job better and safer at the
rate for which it was designed.
b
Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be
controlled with the switch is
dangerous and must be repaired.
c
Disconnect the plug from the
power source before making any
adjustments, changing accessories,
or storing power tools.
Such
preventive safety measures reduce the
risk of starting the power tool
accidentally.
d
Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool.
Power tools are
dangerous in the hands of untrained
users.
e
Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect
the power tool’s operation. If
damaged, have the power tool
repaired before use.
Many accidents
are caused by poorly maintained
power tools.
f
Keep cutting tools sharp and
clean.
Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier to
control.
g
Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed.
Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
5 Service
a
Have your power tool serviced by a
qualified repair person using only
identical replacement parts.
This
will ensure that the safety of the
power tool is maintained.
6 – Safety instructions
relating specifically to
the equipment
• The appliance must be plugged into a
230 V socket fitted with an earthing
contact and a 10 A minimum fuse.
• Do not expose appliance to rain or a
damp environment.
• Always check the appliance for faults
before starting up.
• Clamp workpieces firmly before
working. Never hold them with the hand.
• When sawing and cutting, ensure that
you do not contact nails, screws or
metallic parts.
• To keep noise to a minimum, secure
the workpiece firmly so that it does
not vibrate and ensure that all parts
of the machine are in place and
screwed tight. Always use saw blades
which are clean and undamaged.
• The insertable tools become very hot
during operation. Do not touch them
before they have cooled down.
38
5400630-Kleinbohrm-man 24.01.14 11:50 Seite 38
