53
the manufacturer's service
address specified on the rear
page of these operating
instructions.
4. If possible, store the packaging
until the guarantee period has
come to an end.
Mounting the additional handle
• Attach the clamping ring of the
additional handle (1) in the
desired position by screwing the
tensioning knob (6) tight.
Filling with lubricating oil
(Figure B/C)
NOTE! Risk of damages!
Insufficient lubrication
may result in damage
to the jackhammer. Make
sure that there is always
sufficient lubricating oil in
the tank.
The jackhammer is delivered
without lubricating oil in the tank.
Lubricating oil must be put into the
tank before using the product for the
first time.
1. Open the screw closure for the oil
tank (5) using the wrench (13).
2. Fill lubricating oil (11) into the oil
tank.
3. Close the screw closure of the
oil tank again. You can read
off the oil filling level in the
viewing window of the screw
closure.
Fitting and removing inserted
tools (Figure D)
WARNING! Risk of
injury! There is a risk of
injury caused by an
inserted tool starting up.
Remove the power plug from
the socket before attaching or
removing inserted tools.
CAUTION! Risk of injury!
After working with the
jackhammer, the inserted
tool may be hot and cause
burns. Do not touch the inserted
tool or parts in the vicinity of the
inserted tool immediately after
you have stopped working.
When removing and inserting the
tool, always wear gloves.
1. Pull the locking bolt (7) out gently
and rotate by 180° so that the
tool holder (8) is unlocked.
2. Place the insertion end of the
tool (9/10) into the tool holder
with the groove facing upwards.
3. Pull the locking bolt out gently
and rotate by 180° so that the
tool holder is locked.
4. Check the correct seating of the
inserted tool by pulling on it gently
and jiggling it. The tool may move
slightly, but may not pull out.
5. To remove the tool, pull the locking
bolt out gently and rotate by 180°
so that the tool holder is unlocked.
6. Remove the tool.
5452980-Stemm-Abbr_man 10.01.17 10:41 Seite 53