b)
Always start the drilling process
with a low speed and with the drill
in contact with the workpiece.
When
using with higher speeds, the drill may
bend easily if it is able to rotate freely
without contact with the workpiece,
and result in injuries.
c)
Do not exert excess pressure and
only place pressure in a longitudinal
direction to the drill.
Drills may bend,
and break, as a result or lead to a loss
of control and to injuries.
6 – Safety instructions
relating specifically to
the equipment
• Before drilling holes in a wall, check,
if necessary using a cable detector,
whether you are at risk of contacting
concealed power, gas or water lines.
• Only change a drill/chuck when the
power tool is disconnected from
power supply (unplugged)!
• In order to prevent injuries, ensure
that the work piece to be drilled is
secured (e.g. by clamping in a vice).
• Prevent motor standstill during opera-
tion.
• If the mains cable of the power tool is
damaged, it must be replaced with a
specially prepared mains cable, which
is available from Customer Services.
Safety marks
Symbols on the power tool have the fol-
lowing meaning:
Do not dispose of with the
household waste!
Important! Observe the
operating instructions!
Important! Wear goggles.
Important! Wear ear defend-
ers.
Important! Wear a dust pro-
tection mask.
Voluntary „geprüfte Sicher-
heit“ seal of quality (tested
safety)
CE mark (conformity with
European safety standards)
The housing is double insu-
lated (Double insulation)
BJ
Year of construction
SN:
Serial number
SN: XXXXX The first two underlined num-
bers give the month of man-
ufacture.
7 – Installation and setting
Mounting of auxiliary handle (Fig. 2)
The additional handle (8) can be
attached either to the left or to the right
of the drill chuck (10). Detach the handle
element (a) on the auxiliary handle (8) by
rotating it anti-clockwise until it can be
pushed over the chuck (10) and onto the
collar (b). The locking cam (c) engages
in one of the grooves (d) and prevents
the vibration from causing the additional
handle to move (8). This allows you to
select a comfortable working position.
Tighten the handle (a) by turning it
45
5452220-Schlagbohrmaschine_man.indd 45
5452220-Schlagbohrmaschine_man.indd 45
17.07.20 06:49
17.07.20 06:49
