Operating instructions
Turning the thermostat ON and OFF
Press the [On/Off] button to turn the thermostat ON.
Press again to turn the thermostat OFF.
* The words “ON” or “OFF” will appear on display.
Adjusting the Set point temperature
Press the [+] or [-] buttons once - the word “SET” and the set point
temperature will flash.
Press again to adjust the set point temperature.
* Room temperature display can be disabled by technician.
Tel: +972-3-9626462
Fax: +972-3-9626620
support@meitavtec.com
ETNC24-SUPER-MDB-01
Owner’s manual & Technician Settings
Pg. 3
System Modes
Press the [Mode] button to switch between modes:
- “Cool”…………………..…… Cooling
- “Heat”….…………….…....… Heating
- “Cool” & “Heat”………..….… *Auto mode
- “Fan”….………………..……. Fan only
* In Auto mode, the system mode depends on the difference between room
temperature and set point:
Set point temperature higher than Room temperature Heating mode.
Set point temperature lower that Room temperature Cooling mode.
* Auto mode can be disabled by technician.
* Active mode flashes during demand for cooling or heating.
Economy mode can be used to keep the room temperature at economy
levels during absence.
Economy set points for cool and heat are set by technician.
Press and hold the [On/Off] button for 20 seconds to turn economy
mode ON – “EC” will appear on display.
Press the [On/Off] button again to return to normal mode.
ON
OFF
Thermostat
ON
Thermostat
OFF
Set point
temperature
F
o
Room
temperature
F
o
SET
Cool
Cooling
Heat
Heating
Heat
Cool
Auto
Fan
Fan only
Economy mode
Economy
mode
