Tel: (856) 2882882
Tel: +972-3-9626462
Fax: +972-3-9626620
support@meitavtec.com
PYROCON12
Owner’s manual & Technician Settings
Pg. 10
Cont’
P08 - Snow sensor sensitivity
Press the [SELECT] and [+] buttons simultaneously.
“P08” and the snow sensor sensitivity value will appear on display.
Use the [+] and [-] buttons to adjust the sensitivity.
Range: 20...80 % (20% - Less sensitive, 80% - more sensitive), Default: 50 %
Snow sensor
sensitivity
P88 - Snow detection threshold
Press the [SELECT] and [+] buttons simultaneously.
“P88” and the snow sensor threshold will appear on display.
Use the [+] and [-] buttons to adjust the threshold.
Range: 00...60 minutes
Default: 5 minutes
If the threshold is not reached, the logic of turning the heaters either ON or OFF will
not be affected by snow detection.
During countdown to threshold time, the snow flake icon will flash.
Snow detection
threshold
Technician settings (Cont’)
P07 - Heaters outputs logic controlled by PYROSENSE snow melt sensor or by 3
rd
party sensor
Note: 3
rd
party sensors - i.e. gutter or pavement sensors – CIT, GIT, SIT by eti.
Outputs controlled
by PYROSENSE
Outputs controlled
by 3
rd
party sensor
0
All outputs
-
1
1,2,3,4
5
2
-
All outputs
3
Comments
The display will not show the ambient
temperature and will remain blank.
Outputs 4 and 5 will turn ON or OFF together.
Default.
Outputs 4 and 5 will turn ON or OFF together.
1,2,3
4,5
Value
Press the [SELECT] and [+] buttons simultaneously.
“P07” and the figures “0”, “1”, “2” or “3” will appear on display.
Use the [+] and [-] buttons to define the heaters logic (model dependent) as follows:
1-5 by PYROSENSE
4 & 5 Together
1-4 by PYROSENSE
5 by 3
rd
party sensor
1-5 by 3
rd
party sensor
1-3 by PYROSENSE
4-5 by 3
rd
party sensor
