File: rt03.doc
- 4 -
Rev. 1, May 4, 2005
•
Press the SELECT button - the TIMER will blink
•
Select TIMER ON (black icon) or OFF
(white icon) using the (+) or (-) buttons.
•
Press the ON/SEND button to send the
information to the thermostat.
Important: when the Timer is active, and there is power failure to the thermostat,
the display will show “ON” flashing.
8. Batteries
Replacement
When the batteries are low, the display of the remote control will dim.
If the batteries will not be replaced the display will turn off completely.
Batteries replacement:
Pull the batteries cover down to reveal the batteries.
Remove the old batteries.
Wait for 10 minutes before installing the new batteries.
Install two new AAA batteries – Pay attention to the polarity.
Return the batteries cover to place.
Important: The remote control will not operate unless at least 10 minutes pass
between removing the old batteries and installing the new ones.
