meitav-tec SUPER-SI Series User'S Manual & Installation Instructions Download

Page: 1 / 4

05.13 Ref. 201067 Rev. 101

SUPER-SI THERMOSTAT

User manual
Installation and Operation Instructions

Contents

Page

1. Installation Instruccions

2. Wiring connections

3. Micro Switch DIP Adjustments

4. Operation Manual

4.1Switch on / Switch off

4.2 Temperatures adjustment

4.3 System modes

4.4 Fan / autofan ventilation

4.5 Blocking / unblocking of thermostat buttons

1. Installation Instructions

- Separate the front panel of the back panel pressing the tab located at the top of the

unit.

- Remove the back panel.

- Align the back panel on the wall or a plain surface. Install 3 necessary screws

- Realize electrical connections as shown in electrical wiring diagram (attached on

the next page).

- Install the back panel’s cover; first of all two clips on the bottom and then the

upper tap. Push until it would be fixed on the wall.

On/Off Mode

Fan

Cool
Heat

SET

ON
OFF

Summary of Contents for SUPER-SI Series

Page 1: ...locking unblocking of thermostat buttons 4 1 Installation Instructions Separate the front panel of the back panel pressing the tab located at the top of the unit Remove the back panel Align the back p...

Page 2: ...ECTRIC RESISTANCE 1 PHASE W3 ELECTRIC RESISTANCE 3 PHASE B O HEAT PUMP 4 WAY VALVE C ORDINARY supply R LINE supply 3 Micro Switch DIP Adjustments Important SET MICRO SWITCH WITHOUT SUPPLY ENERGY IN TH...

Page 3: ...e External sensor Only cool or cool with heating stage Heat Pump V4V S2 1 ON OFF S2 2 OFF ON S2 3 ON OFF S2 4 OFF ON SWITCH S2 In screen Cooling with heating stage config Heat pump config V4V Ambient...

Page 4: ...the buttons o to select the automatic Fan Status o With Fan Auto Display Auto Fan on the screen Fan only will work when there is a cool or heat request o Without Fan Auto Display only Fan on the scree...