SECTION 4 - OPERATING INSTRUCTIONS
4. Position THROTTLE LEVER (Figure 4-5) to “LOW” speed position.
Avoid fully pulling out the rope. Return the Handle to its original position.
5.Pull the STARTER HANDLE (1, Figure 4-4) of RECOIL STARTER slowly until resistance is felt. This is the “COMPRESSION”
point. Return the Handle to its original position and pull swiftly. After starting the engine, allow the Starter Handle to return
to its original position while still holding the Handle.
Figure 4-4
After the engine starts, set the Throttle Lever (Figure 4-5) at the low speed position “LOW” and warm it up without load for a few
minutes. Fully open CHOKE LEVER (1, Figure 4-3) gradually.
4-4
Summary of Contents for KP30A
